Profesor Investigador de Tiempo Completo VI,SNI Nivel I

Dr. Jorge Alberto Morales Saldaña


Jorge Alberto Morales Saldaña recibió el grado de licenciatura y  Maestría en Ingeniería eléctrica de la Universidad Autónoma de San Luis Potosí en 1995 y 1997. Obtuvo el grado Doctor en Ingeniería Eléctrica de la Universidad Autónoma de San Luis Potosí en 1999. En el año de 2000 Fue profesor interino en el InstitutoTecnológico de San Luis, y desde ese año se incorporó a la Facultad de Ingeniera de la Universidad Autónoma de San Luis Potosí como profesor investigador. Desde el año 2000, es miembro del Sistema Nacional de Investigadores (SNI), y actualmente es Investigador Nacional Nivel I. Desde el 2004, tiene el Reconocimiento de Perfil PROMEP que extiende la Secretaria de Educación (SEP). Es autor de más de 30 trabajos científicos entre revistas indizadas, foros internacionales y nacionales. Ha graduado a un total de 10alumnos de posgrado, de ellos, dos doctorados que actualmente pertenecen al SNI. Es revisor de la revista IEEETransaction On Power Electronics y IET PowerElectronics..

             Doctorado en Ingeniería Eléctrica (1997-1999)

            Universidad Autónoma de San Luis Potosí

            San Luis Potosí, S.L.P., México

 

            Maestría en Ingeniería Eléctrica (1995-1997)

            Universidad Autónoma de San Luis Potosí

            San Luis Potosí, S.L.P., México

 

            Licenciatura en Ingeniería Eléctrica (1987-1992)

            Universidad Autónoma de San Luis Potosí

            San Luis Potosí, S.L.P., México

Sin Contenido
Sin Contenido
Sin Contenido

PUBLICACIONES EN SCIENCE CITATION INDEX 

 

 

1.J.A. Morales-Saldaña,R. Loera-Palomo and  E. Palacios-Hernandez, “Modeling and Control of DC-DC Quadratic Boost Converter with R2P2”, IET POWER ELECTRONICS, Aceptado 2013Indizada JCR.
2.R. Loera-Palomo, J.A. Morales-Saldaña and  E. Palacios-Hernandez, “Quadratic Step-down DC-DC Converters based on Reduced Redundant Power Processing Approach”, IETPOWERELECTRONICS,Aceptado 2013Indizada JCR.
3.R. Loera-Palomo, J.A. Morales-Saldaña and  J. Leyva-Ramos “Signal Flow Graphs for Modelling of Switching Converters with Reduced Redundant Power Processing”, IET POWER ELECTRONICS, 2012, 5(7), pp. 1008-1016. Indizada JCR.
4.R. Loera-Palomo, J.A. Morales-Saldaña, J. Leyva-Ramos and E.E. Carbajal-Gutierrez “Controller Design for a PFC Regulator R2P2”, IET POWER ELECTRONICS, 2010, 3(5), pp. 784-792. IndizadaJCR
5.H I Medellin*, D F de Lange, J. Morales, and A Flores “Experimental study on electrodischarge machining in water of D2 tool steel using two different electrode materials” Proc. IMechE Vol. 223 Part B: J. Engineering Manufacture, 2009. pp. 1423-1430.Indizada JCR
6.J. Leyva-Ramos, M. G. Ortiz-Lopez, L. H. Diaz-Saldierna and J. A. Morales-Saldaña \"Switching regulator using a quadratic boost converter for wide DC conversion ratios\". IET POWER ELECTRONICS,2009. 2 (5), 605-613. Indizada JCR
7.M. G. Ortiz-Lopez, J. Leyva-Ramos, E. E. Carbajal Gutierrez and J. A. Morales-Saldaña \"Modelling and Analysis of Switch-Mode Cascade Converters with a Single Active Switch\". IET POWER ELECTRONICS.2008 ;1 (4) :478-487. Indizada JCR
8.J.A. Morales-Saldaña, J. Leyva-Ramos, E.E. Carbajal-Gutierrez and M.G. Ortiz Lopez, “Average Current-Mode Control Scheme for a Quadratic Buck Converter With a Single Switch”, IEEE TRANSACTION ON POWER ELECTRONICS, 2008; 23; 485-490. IndizadaJCR.
9.J. A. Morales-Saldaña, R. Galarza-Quirino, J. Leyva-Ramos, E. E. Carbajal-Gutierrez and M.G. Ortiz-Lopez, “Multiloop Controller Design for a Quadratic Boost Converter”, IEE PROCEEDING-. ELECTRIC POWER APPLICATIONS. 2007, 1 (3) pp. 362-367. IndizadaJCR.
10.J. Leyva-Ramos and J.A. Morales-Saldaña, “Computation of delay intervals for stability of time-delay systems”, Applied MATHEMATICS AND COMPUTATION, Elsevier Science Inc., pp. 980-989, Vol. 183, No. 2, December 2006Indizada JCR.
11.E.E. Carbajal-Gutiérrez, J. A. Morales-Saldaña and J. Leyva-Ramos, “Modeling A single-switch of A Quadratic Buck Converter”, IEEE TRANSACTION, ON AEROSPACE AND ELECTRONIC SYSTEMS, pp. 1451-1457, Vol. 41, No. 4, October 2005IndizadaJCR.
12.J. Leyva Ramos, J. A. Morales-Saldaña, and MargaritoMartínez, ”Robust Stability Analysis For Current Programmed Regulators ”, IEEE TRANSACTION, ON INDUSTRIAL ELECTRONICS, pp.1138-1145, Vol. 49, No.49, October 2002Indizada JCR.
13.J. A. Morales-Saldaña, J. Leyva Ramos. and E.E. Carbajal Gutierrez, ”Modeling of Switch Mode DC-DC Cascade Converters”, IEEE TRANSACTION, on AEROSPACE AND ELECTRONIC SYSTEMS, pp.295-299 Vol. 3, No.1 January 2002Indizada JCR.
14.Leyva-Ramos J., Morales-Saldaña J. A. and Vital-Ochoa Omar “Mu-Stability Analysis for Current Programmed Regulators”. APPLIED MATHEMATICS AND COMPUTATION. Editorial ELSEVIER SCIENCE INC., pp. 1-14, 2001Indizada JCR.
15.Leyva-Ramos J. and Morales-Saldaña J. A., “Uncertainty Models for Switch-Mode DC-DC Converters”, IEEE TRANSACTION. ON CIRCUITS AND SYSTEMS – PART I: FUNDAMENTAL THEORY AND APPLICATIONS, pp. 200-203, Vol. 47, No. 2, February 2000Indizada JCR.
16.Leyva-Ramos J. and Morales-Saldaña J. A., “A Design Criteria for the Current Gain in Current Programmed Regulators”, IEEE TRANSACTION. ON INDUSTRIAL ELECTRONIC, pp. 568-573, Vol. 45, No. 4, 1998Indizada JCR.

 

PUBLICACIONES EN CONGRESOS INTERNACIONALES

1. J. Leyva-Ramos, M. G. Ortiz-Lopez, J. A. Morales-Saldaña, and L. H. Diaz-Saldierna \"The effect of ESR of the capacitors on modeling of a quadratic boost converters\" en 11Th IEEE Control and Modeling for Power Electronics. IEEE Zurich, Suiza. agosto 2008.

2. R. Loera-Palomo, J.A. Morales-Saldaña and E.E. Carbajal-Gutierrez, “Modeling and Control of a PFC Regulator with Reduced Redundant Power Processing”, IEEE Power Electronics Specialists Conference,  PESC 2008, Rhodas, Grecia, Junio 2008.

3.  J.A. Morales-Saldaña, R. Galarza-Quirino, J. Leyva-Ramos, E.E. Carbajal-Gutierrez and M.G. Ortiz-Lopez, “Modeling and Control of a Cascaded Boost Converter with a Single Switch”, IEEE Industrial Electronics Conference, IECON06, Paris, Francia Diciembre 2006.

4. E.E. Carbajal-Gutiérrez, J. A. Morales-Saldaña and J. Leyva-Ramos, “Average Current-Mode Control for a Quadratic Buck Converter”, IEEE Power Electronics Specialists Conference, PESC05 June 12-16, 2005, Recife, Brasil.

5.E. E. Carbajal-Gutiérrez, J. A. Morales-Saldaña, J. Leyva-Ramos y M. Martínez-Cruz, “Diseño de un Controlador-PI para un Convertidor Elevador de dos Etapas”. Latin-American Conference on Automatic Control, CLCA 2002, Guadalajara, México, December 3-6, 2002.

6.B. Lara-Lara, J. A. Morales-Saldaña, E. E. Carbajal-Gutiérrez y J. Leyva-Ramos, “Control de Convertidores Elevadores en Cascada en Modo Corriente”. Latin-American Conference on Automatic Control, CLCA 2002, Guadalajara, México, December 3-6, 2002.

7.J.Leyva-Ramos, J. A. Morales-Saldaña and M. Martinez-Cruz “On the computation of delay intervals for robust stability of uncertain Time-delay Systems”. 9th Bellman Continuum, International Workshop on Uncertain Systems and Soft Computing, Beijing, China, July 24-27, 2002.

8. Morales-Saldaña J. A. and Leyva-Ramos J. “A Method For The Derivation Of Uncertainty Models Of Power Electronics Circuits”. 8th Bellman Continuum, Taipei, Taiwan, December 12, 2000.

9.Leyva-Ramos J. and Morales-Saldaña J. A.  “Modeling of Current-Programmed Converters with Inductor Current Sensing”. 9th IEEE International Conference on Control Applications, Anchorage, Alaska, September 27, 2000.

10. Leyva-Ramos J., Morales-Saldaña J. A. and Vital-Ochoa Omar “μ-Stability Analysis for Current Programmed Regulators” The 7th Bellman Continuum International Workshop on Computation, Optimization and Control, Santa Fe, New Mexico, USA: May 24-25 1999.

11.Leyva-Ramos J. and Morales-Saldaña J. A. “Damping in current Programmed Regulators”, The 36th IEEE Control on Decision Conference, San Diego LA, December 1997.

12.Leyva-Ramos J. and Morales-Saldaña J. A. “PI Controller Design for High Frequency Switching Regulators,” 3rd. SIAM Conf. Contr. And Its App., St. Louis Missouri, April. 27-29, 1995.

 

 

 

 

1.- “Modelado y Control de Convertidores CD-CD con Procesamiento de Potencia Redundante Reducida para Corrección de Factor de Potencia”

Responsable: Dr. Jorge Alberto Morales Saldaña.

Financiado por: Fondo Sectorial de Investigación para la Educación SEP CONACYT 2004.

Duración 3 años.

2.- “Modelado y Control de Convertidores Cuadráticos de CD-CD”

Responsable: Dr. Jorge Alberto Morales Saldaña.

Financiado por: Fondo de Apoyo a la Investigación  (FAI), UASLP. Año 2004

Duración 1 año.

3.- “Diseño de Controladores para Reguladores de CD-CD Multietapas”

Responsable: Dr. Jorge Alberto Morales Saldaña.

Financiado por: PROMEP. Año 2002

Duración 1 año.

 

Sin Contenido

Estancia Sabática en el Laboratorio de Electrónica de Potencia y Sistemas de Control del Instituto Potosino de Investigación Científica y Tecnológica, IPICYT de Enero-2010 a Enero 2011, desarrollando el proyecto “Análisis deConvertidores conmutados de CD-CD con Procesamiento de Potencia Redundante Reducida”, en colaboración con el Dr. Jesus Leyva Ramos (S NI III).

Sin Contenido

 

 

 

 

SISTEMA NACIONAL DE INVESTIGADORES (SNI)

1        Investigador Nacional Nivel I (2015-2018)

2        Investigador Nacional Nivel I (2011-2014)

3        Investigador Nacional Nivel I (2008-2010)

4        Investigador Nacional Nivel I (2004-2006)

 

5        Candidato a Investigador Nacional (2000-2003)

 

 

PERFIL PROMEP

1        Reconocimiento de Perfil Deseable PROMEP (2013-2019)

2        Reconocimiento de Perfil Deseable PROMEP (2010-2013)

3        Reconocimiento de Perfil Deseable PROMEP (2007-2010)

 

4     Reconocimiento de Perfil PROMEP (2004-2007)